• IMALlama@lemmy.world
    link
    fedilink
    arrow-up
    5
    ·
    2 months ago

    Rinsing rice does wonders. Without a rice cooker you’ll need to strain it, but it’s still worth it.

    1. Measure rice by volume. Let’s say 2 cups worth
    2. Put into fine colendar and rinse until the water comes out clear. Mixing with your hand will speed this up. You can also do this in the pot you’re going to cook in and dump water out
    3. Put strained rice in your pot
    4. Add cold water. The ratio of water to rice matters a lot and varies by species of rice. The ratio will be printed on whatever container your rice came in. For Jasmin rice it’s 2 water to 1 rice, so for our two cups of rice you’ll need 4 cups of water
    5. Cover, turn on medium-high heat, being to boil. Don’t go far because it will boil over when it does boil
    6. Turn the heat down to low, crack the lid, and set a timer. The amount of time needed will vary based on rice. For Jasmin, 15 minutes is a good check-in time
    7. Pop the lid. See water bubbling up? If yes, replace lid and come back in a few minutes. If not, use a wooden spoon to get a peek at the bottom of the pot. See water? If yes, replace lid and come back fairly soon to check again. If not, your rice is done. Turn the heat off, fluff, enjoy.

    We made rice for years using this method and it is a very reliable cooking method. Rice doesn’t really leave you a lot of wiggle room though, which is where a rice cooker comes in handy. As an added bonus, some rice cookers come with water lines in them. I measure my dry rice into the cooker, rinse using the cooker, dump most of the water out, and fill to the appropriate level.

    Different species of rice have very different textures and somewhat (subtle) different flavorss.

    Some rice, like basmati, can be cooked using the pasta method (intentionally use way too much water and strain the excess off after the rice is cooked). I guess all rice could be cooked that way, but you would be giving up some starch.