• Em Adespoton@lemmy.ca
    link
    fedilink
    arrow-up
    13
    ·
    edit-2
    2 days ago

    Depends on what the air purifier was filtering. Mine does PM10, PM2.5, VOC and NO2. That means it’s filtering out particles down to 2.5mm plus volatile organic compounds (smoke, aerosolized oils, water vapour with pathogens, etc) and nitrous oxide.

    The filter is a multi stage filter; the PM2.5 stuff passes right through the PM10 filter.

    Interestingly, if I want to clear a room of smoke, sawdust, drywall dust or similar, what works the best is running my shop vac with a HEPA filter installed until I can’t smell the dust/smoke (usually around 5 minutes) and then I turn my air filter on full blast and it clears up the air in around 20 minutes. If I just used the air filter, I’d probably clog it up and then just have to replace the comparatively expensive filter.

    • Davel23@fedia.io
      link
      fedilink
      arrow-up
      13
      ·
      2 days ago

      Should probably point out that “mm” in this case is micrometers, not millimeters.

      • Instigate@aussie.zone
        link
        fedilink
        arrow-up
        4
        ·
        1 day ago

        Thank you for that clarification; I was genuinely wondering why anything smaller than 2.5 millimetres would pass through an air filter! When it comes to filtering air, 2.5 millimetres is MASSIVE

      • Em Adespoton@lemmy.ca
        link
        fedilink
        arrow-up
        2
        ·
        1 day ago

        No; however, you essentially have a line between price and noise, and you need to check what they filter, how expensive the filters are, and how often they need to be replaced, as well as how much it costs to run them.