Sjmarf@sh.itjust.works to Memes@lemmy.ml · 10 months agoThe size of a whatsh.itjust.worksimagemessage-square56fedilinkarrow-up1905arrow-down127
arrow-up1878arrow-down1imageThe size of a whatsh.itjust.worksSjmarf@sh.itjust.works to Memes@lemmy.ml · 10 months agomessage-square56fedilink
minus-squarejusthach@lemmy.worldlinkfedilinkarrow-up130·10 months agoAmericans will use anything but metric smdh.
minus-squareqisope@lemmy.worldlinkfedilinkarrow-up36·10 months agoyou’re not legally allowed to call them feet then
minus-squareSotuanduso@lemm.eelinkfedilinkEnglisharrow-up16·10 months agoYou can get around those rules by spelling it wrong. Pheet.
minus-squarelugal@lemmy.mllinkfedilinkarrow-up9·10 months agoOk, my pheet are 0.83 pheet long Much better
minus-squareFlying Squid@lemmy.worldlinkfedilinkarrow-up3·10 months agoWhatever king it was had really big feet though.
minus-squaren7gifmdn@lemmy.calinkfedilinkEnglisharrow-up13arrow-down1·10 months agoI hope you are joking. There are no decimals in standard measuring systems. Decimals are a Communist plot. ;-)
minus-squareRodeo@lemmy.calinkfedilinkarrow-up1·10 months agoUnless you’re doing any kind of precision manufacturing, then it’s decimal inch notation.
minus-squareBizzle@lemmy.worldlinkfedilinkEnglisharrow-up1·10 months agoThe steel that I cut has thickness measured in millimeters, the program wants it in fraction inches, and the torch spacing is in decimal inches. It’s a catastrophe but Im getting pretty good at in/mm conversion
Americans will use anything but metric smdh.
My feet are 0.83 feet long
you’re not legally allowed to call them feet then
You can get around those rules by spelling it wrong.
Pheet.
Ok, my pheet are 0.83 pheet long
Much better
Feetish
Whatever king it was had really big feet though.
I hope you are joking. There are no decimals in standard measuring systems. Decimals are a Communist plot. ;-)
83/100 feet
Unless you’re doing any kind of precision manufacturing, then it’s decimal inch notation.
The steel that I cut has thickness measured in millimeters, the program wants it in fraction inches, and the torch spacing is in decimal inches. It’s a catastrophe but Im getting pretty good at in/mm conversion